Fiberglass Self-adhesive Mesh Tape
Fiberglass self-adhesive mesh tape is made by cutting alkaline
resistant fiberglass fabic coated
with acrylic copolymer.Excellent self-adhesive so no
pre-plastering.Good alkali-resistence high
tensile strength and resistance to deformation lead to durable in
use.It won’ t tear stretch shrink
or bubble.Convenient application in construction.The fiberglass
self-adhesive mesh tape is prefect commercial or residential
application of drywall finishing repairing the cracks and joints or
holes of drywall, plasterboard, stucco and the other surface.
Width( mm) : 25, 35, 48, 50, 100, 150, 200, 1000, 1200
Length( m) : 10, 20, 30, 45, 90, 153
Weight: From 55 to 85g/ sq.meter
Mesh: 8x8 or 9x9mesh/ inch
Colour: White, yellow, blue etc…
Jumbo roll: 1200mm x450m or1200mm x900m
Drywall seaming tapes as well as private label and unlabel tapes.
Each roll is shrink-wrapped, or plastic hand bag.
Other specification are available upon request.
Testing Standard: ASTM-D579
How To Use:
1. Wall must be clean and dry;
2. Center and apply tape over the length of the joint and pressing
3. Apply a generous first coat of compound over the tape and
through the mesh, making sure to completely fill the joint
crevice.When the joint has been completely filled, wipe off any
excess compound with the drywall knife leaving enough to cover the
4. Let dry completely, then sand slightly.
5. Apply sufficient thin finishing coats to produce a smooth wall
6. Cut of butted boards do not have a tapered edge.Therefore,
special care must be taken to assure proper compound penetration of
all joints.This may result in slight build-up of compound that
require an increased amount of edge feathering.
Product shall be placed under dryness condition and no be open the
membrane until applying.
Failure to completely fill the joint may result in cracking.
For best results, use a setting-type compound.
fiberglass selfadhesive tape Images